• 3D Model

Info

Added: Oct 27, 2017 03:39
Author: sam DC
License: Creative Commons - Attribution - Share Alike

Description

These are the plans to make a simple wind turbine.

The turbine is made from plastic and paper to reduce weight, add efficiency and lower print time and cost.

This is the first revision of the turbine. If you try to make it and encounter some problems, don't hesitate to let me know.

Instructions

This turbine is made with simplicity in mind.

The file TurbineSmallRev1.STL will print in about 30 minutes with a layer hight of 0,3mm.

The blades are made of paper. Here in Belgium, we have square paper with a width of 89mm. The length isn't as important. (If you can't find the right paper, let me know, i will make another version.)

The blades need a few drops of glue to hold them in place.

If you have a motor with a small shaft you can use the adapter AsRev1.STL.

If there are any suggestions to make this better, let me know.

Files

File name File size
AsRev1.stl 21.96 KB
TurbineSmallRev1.STL 130.55 KB
AsRev1_preview_featured.jpg 36.99 KB
image_preview_featured.jpg 72.53 KB
Schermafdruk_2015-06-19_10.22.54_2_preview_featured.jpg 30.49 KB
TurbineSmallRev1_preview_featured.jpg 47.95 KB

Leave a Reply