• 3D Model

Info

Added: Jan 02, 2018 07:27
Author: Michele Pattaro
License: Creative Commons - Attribution

Description

I buyed a digital depth gauge for levelling the bed of my CR-10S, but printable holders found on line do not fit my gauge
This is 2 part print that must be glue together (see picture for final assembly)
Print with your everyday settings, glue with CA et voila.

One note... this type of digital gauge, as opposed to the dial type, require a use of a rubber band for pull down the needle.
Alternatively, you can remove the spring that stiffen the needle (it require you remove the 4 screws under the sticker on the rear, remove the cover, then take apart the needle. the spring is a flat metallic sheet underneath the needle plastic).

Files

File name File size
LICENSE.txt 215.00 B
README.txt 2.16 KB
attribution_card.html 1.96 KB
files/cr-10-adapter.stl 64.93 KB
files/Digital-gauge-holder.stl 12.29 KB
images/a25a242464c21d72298bfc5e0a2206e5_preview_featured.jpg 18.29 KB
images/55e2f629400ec876e642579268a391df_preview_featured.jpg 19.90 KB

Leave a Reply