• 3D Model

Info

Added: Jan 03, 2018 03:42
Author: Geoff Merck
License: Creative Commons - Attribution

Description

After replacing 2 of these fans because of my fingers catching a blade, I finally got around to making this snap-on guard. Using the 2 unused holes in the fan, the pins hold the guard to the fan, but still allow access to the hex screws to remove in case of a jam. Tooth design helps it fit the hole without being too tight.

Printed at .2mm height with PLA, 100% infill would make the pins a bit stronger, but not necessary. 12 minute print that could save hours or days of waiting for a new fan to arrive.

Print Settings

Printer:

Qidi Tech X-One

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

30%-100%

Files

File name File size
LICENSE.txt 176.00 B
README.txt 2.09 KB
attribution_card.html 1.93 KB
files/40mm_Fan_Guard.stl 91.78 KB
images/bce90238ae33a5b667ff3255bdb2381f_preview_featured.jpg 85.46 KB
images/ee4c4c22c4e235ae62ac7395720daa15_preview_featured.jpg 43.20 KB
images/9431600589929d99425561f748d967d9_preview_featured.jpg 76.24 KB
images/d0aa4e0529b1e31ee1a2cc68f855331d_preview_featured.jpg 86.68 KB

Leave a Reply